7/25/2023 0 Comments Shell script debugger eclipseClick on "Yocto Project ADT" from the left options and then under "Cross Compiler Options:" select the "Standalone pre-built toolchain" radio button.Select "Preferences" from the "Window" menu. These will then be used as default for your projects from within your workspace. In this section we will configure the Cross Compiler and the Target options. Make sure the repository above is selected on the "Work with" drop-down menu and select the following plug-ins from the list:ģ.4 Configuring the Eclipse Yocto Plug-in.Name: Yocto Jethro (you can actually use any name) Click the "Add." button to add a repository, enter the following and click OK.In Eclipse, select "Install new Software" from the "Help" menu. Click to restart Eclipse when asked to.ģ.3 Adding the Yocto Plug-in to the Eclipse IDE.If asked if you trust the Eclipse certificates, make sure you select the certificates and click OK.Click Next twice, accept the necessary EULA and click Finish.Expand the "Programming Languages" option and select:.Expand the "Mobile and Device Development" option and select:Ĭ/C++ Remote Launch (Requires RSE Remote System Explorer).Expand the "Linux Tools" option and select:.Uncheck the "Hide items that are already installed" box.In the "Work with" area select "Luna - ".Select a new workspace (you can just click OK).Ĭhoose "Install New Software" from the "Help" pull-down menu. Run the Eclipse IDE with the following command: $ tar -xf ~/Downloads/eclipse-cpp-luna-SR2-linux-gtk-x86_64.tar.gz Run the following command to unpack and install the downloaded Eclipse IDE tarball into a clean directory using the default name eclipse: opt/fsl-imx-x11/4.1.15-1.1.0/environment-setup-cortexa9hf-vfp-neon-poky-linux-gnueabiģ Eclipse installation 3.1 Download Eclipse SDK has been successfully set up and is ready to be used.Įach time you wish to use the SDK in a new shell session, you need to source the environment setup script e.g. Proceed?" hit y and enter.Īt the end of the installation you should see the following: When system prompts "You are about to install the SDK to "/opt/fsl-imx-x11/4.1.15-1.1.0". When system prompts "Enter target directory for SDK (default: /opt/fsl-imx-x11/4.1.15-1.1.0):" hit enter. 3.4 Configuring the Eclipse Yocto Plug-inġ Create your rootfs with Eclipse debug supportĪppend the following to the conf/nf file in your Yocto build directory:Ĭhange directory to your build directory and verify that your environment settings is set correctly.3.3 Adding the Yocto Plug-in to the Eclipse IDE. ![]() 1 Create your rootfs with Eclipse debug support.
0 Comments
Leave a Reply. |